• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Poplar & resin.

Paul hd

Fellow
Joined
Jun 12, 2016
Posts
1,299
Location
Buckinghamshire
First Name
Paul
Hi All,

Poplar burl and a bit of Pearl-X Gold.
The bushings are no good as the finish was way under the fittings. No problem as I can take the pen apart and start again with new bushings. All good practice.

Gold resin - YouTube
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
I use two calipers following a bad experience twenty years ago one for each end measured at the fittings each time. I appreciate your dilemma Paul, it is a most beautiful blank.

Peter.
 

Paul hd

Fellow
Joined
Jun 12, 2016
Posts
1,299
Location
Buckinghamshire
First Name
Paul
I use two calipers following a bad experience twenty years ago one for each end measured at the fittings each time. I appreciate your dilemma Paul, it is a most beautiful blank.

Peter.
Thanks Peter,
From now on I will measure the bushings. I recently used a vernier for a key ring project as I didn't have the correct bushings and it worked out ok.
 

fortress

Registered
Joined
Apr 11, 2016
Posts
5,178
Location
Astley
First Name
John
A lovely blank Paul, it's a shame about the bushings, great video as always, thanks for showing. :drool:
 

Graham_C

Fellow
Joined
Feb 1, 2017
Posts
1,153
Location
Tywyn
First Name
Graham
I love the way you experiment and share the good, bad and ugly with us Paul. Thanks again :thumbs:
 

Paul hd

Fellow
Joined
Jun 12, 2016
Posts
1,299
Location
Buckinghamshire
First Name
Paul
I love the way you experiment and share the good, bad and ugly with us Paul. Thanks again :thumbs:
Hi Graham,
I enjoy making the vids and don't really mind if the item doesn't end up perfect. I have had a few occasions where the project has gone flying off the lathe but unfortunately I didn't have the camera rolling. I would love to post something like that.

Regards
Paul
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top