• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

its been a day of firsts

flexi

Executive Member
Joined
Sep 12, 2014
Posts
6,159
Location
Maidstone
First Name
mark
That's very different... Interesting blank, :thumbs::thumbs:
I only polish acrylic or resin blanks:thumbs:
 

ValleyBoy

Graduate Member
Joined
Jul 9, 2019
Posts
643
Location
Cardiff
First Name
Ash
Nice pen.

I rarely offer unsolicited advice on here but, a little tip, you don't need to add CA to resin/plastic pens. Just sand and polish the resin itself. By adding CA you're effectively adding a "plastic" layer to something that is already plastic. (I am using the term plastic in quite a simplistic way here, but it serves to make the point).

CA is typically used on wood when seeking a glossy finish that you can't get from wood alone.

I hope that helps.

Cheers
Ash
 

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,301
Location
Somewhere in Staffordshire,
First Name
Eamonn.
Yep, nice looking pen.

+1 for no CA on Acrylics. But mixed acrylics with pine cone or hybrid blanks I “may” (using that as might, depends on the blank) do then, just to seal the wood parts to get them to look like the acrylics.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top