• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Stands

Dalboy

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,681
Location
Kent
First Name
Derek
OK not anything fantastic but started making some stands one for holding the blank mould pipes I also cot 6 of each size pipe the smaller are 3/4" and the large are 1", and made a stand to hold 2 cups for mixing resin knowing how I am I thought it would be a good idea. No pictures of the silicon block mould yet. I might even make a vibrating table if my attempts at casting go well.
 

Attachments

  • DSCF4487.jpg
    DSCF4487.jpg
    72.9 KB · Views: 63
  • DSCF4489.jpg
    DSCF4489.jpg
    59.3 KB · Views: 62
  • DSCF4488.jpg
    DSCF4488.jpg
    63.9 KB · Views: 62
Dalboy

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,681
Location
Kent
First Name
Derek
I know I could buy corks for the bottom of the tubes but I will turn some instead, once they are done I will have every thing to start well that is when I get some resin and colouring which hopefully is winging its way to me at the moment. This first lot is going to be the most expensive ones from here on they should start to become cheaper, will just have to see
 
paulm

paulm

grave manibus faciendum
Registered
Joined
Oct 7, 2013
Posts
12,046
Location
Sandford
First Name
Paul
Very nice Derek, I can already see that your blanks are going to be spot on :thumbs:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top