• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Replacing the 12 inch sanding disk

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
One task I put off, dreading the stripping to achieve this result I gave it a go cutting off half of the old disk, the pulling off from the Velcro the other half.

A light brushing then no way was the gap sufficent to let the new disk through.

So I went to a roll of Jack Paper I had bought in 1973 and been using it ever since(used to mount big pics). The roll is One Yard wide. Just double sided tape really with release paper.

I cut a rough circle but tight on the sides cause the machine has hardly any gap at the sides. Slipped the Jack Paper in front of the velcro side aligned the disk slipped the release paper and magic replacement in two minutes.

Job done huge sigh of relief. In the past I have used Cow Gum to hold the disk (pain in the bum to change). Changed all my larger disks over to velcro.

My tip for today works for me. One blank faced r/h not faced yet.

Peter.
 

Attachments

  • DSCF0003.JPG
    DSCF0003.JPG
    105.6 KB · Views: 47
  • DSCF0001.JPG
    DSCF0001.JPG
    90.1 KB · Views: 47
  • DSCF0002.JPG
    DSCF0002.JPG
    54.5 KB · Views: 47
  • DSCF0004.JPG
    DSCF0004.JPG
    21.9 KB · Views: 47
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top