• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

mahogany pen

yorkshireman

Wood Rat
Executive Member
Joined
Jan 5, 2013
Posts
5,199
Location
wrexham
First Name
Keith
Its actually much better than the photo shows Jim. I took it to 400 grit then burnished with shavings. 5 coats of WTF then cut back. Another 4 coats of WTF then leave for 1 hour - recommended to be left 24 hours but I was short of time. A coat of EEE then finish off with Huts friction polish. WTF is water based so dries in not much more than 1 minute so its fairly quick to apply. The finish is good but I must try leaving it for 24 hours to fully cure next time before polishing.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top