• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

home made pen mould

turnaround360

Caracktycus Pots
Fellow
Joined
Mar 6, 2013
Posts
2,427
Location
Essex
First Name
Frank
I had a go at making some moulds
on the hole they are ok but the lugs are a bit big and will need triming but its a start Frankie


frankie.jpg
 

Buckeye

ペンメーカー
Executive Member
Joined
Oct 15, 2013
Posts
9,697
Location
UK
First Name
Peter
Don't trim the lugs until you have tried them, you need to have a good seal.

Peter
 

turnaround360

Caracktycus Pots
Fellow
Joined
Mar 6, 2013
Posts
2,427
Location
Essex
First Name
Frank
No it was holes drilled to form the plug silicone
fills the hole when you remove the former the grommit is left
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top