• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Around the workshop

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
The old now Vicmarc VL100 relocated next to the Carvery.Three phase VFD single phase to three phase with a Garry Pye imported Collet chuck and made in Canberra for me Mandrel Saver high quality steel. This lathe for finishing on the VFD shown open. Been using it for donkeys years now love it. In use it standing no probs it faces the VL150 Vicmarc.

Kind regards Peter.:thumbs:
 

Attachments

  • DSCF0004.jpg
    DSCF0004.jpg
    76.8 KB · Views: 52
  • DSCF0009.JPG
    DSCF0009.JPG
    128.6 KB · Views: 51
  • DSCF0012.JPG
    DSCF0012.JPG
    135 KB · Views: 51
  • DSCF0013.JPG
    DSCF0013.JPG
    78.7 KB · Views: 51
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top