• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Accessory to cut metals on my Hercus Lathe

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
Using a truck purposed aluminium extrusion designed to house truck tray swivels it was a nice fit to hold a Dremel tool, then turned a platform to fit on my Hercus Metal Lathe to cut tool steel, cartridge brasses, cut a groove for circlips on round rod etc. this fits where the tool rest goes.

Kind regards Peter
 

Attachments

  • DCP_2164.JPG
    DCP_2164.JPG
    22.8 KB · Views: 15
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top