• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

About to start using resin

hawkeyefxr

Full Member
Joined
Jan 8, 2015
Posts
373
Location
Yateley Hants
First Name
ken
I have bought some epoxy resin and i about to have a go at filling a hole in a flat piece of wood. I just want to get the hang of mixing it and seeing how it goes from there.
My question is what do a put on the bottom of the hole to stop the resin running out.
cheers
 

martin.pearson

Full Member
Joined
Nov 2, 2017
Posts
223
Location
Balingry Fife
First Name
Martin
What type of resin ? Lots of different types & mixing varies a bit, how deep is the hole? Deep holes may require building up in layers. As for filling the hole it depends on the look you are after, I use different methods for different looks. Sometimes fill the hole with sawdust sometimes leave blank, to stop the resin running straight through a simple bit of tape on the other side is normally enough, good luck, above all have fun learning lol
 

hawkeyefxr

Full Member
Joined
Jan 8, 2015
Posts
373
Location
Yateley Hants
First Name
ken
What type of resin ? Lots of different types & mixing varies a bit, how deep is the hole? Deep holes may require building up in layers. As for filling the hole it depends on the look you are after, I use different methods for different looks. Sometimes fill the hole with sawdust sometimes leave blank, to stop the resin running straight through a simple bit of tape on the other side is normally enough, good luck, above all have fun learning lol

It's Aluminite two part resin.

Green painters tape.

Peter.

Thanks Vic.

Remember that Young lad in Holland ? He done it with his finger :thumbs:

Yea but then i would have to walk around with a 12in dia * 3/4 disk on my finger, plus i cant pick my nose lol
 

Dibbs

Full Member
Joined
Jun 4, 2018
Posts
47
Location
Leeds
First Name
Ian
You need a pressure pot for alumilite otherwise you'll get loads of bubbles. It's awful stuff; I don't know why it's so popular. Glasscast 50 is far easier to use and there's no need for an expensive pressure pot.

Green mould release tape from easy composites to seal holes.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top