• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Field Maple Burr and all its glory!

WHCreations

Full Member
Joined
Jun 5, 2019
Posts
91
Location
surrey
First Name
william
I recently picked up some field maple burr. I have never used it personally and thought it looked a tad rubbish. Well it has been sitting outside until I could get some replacement blades on the bandsaw and when I started I realised I had something rather special.
20190704_135105.jpg20190704_133109.jpgIMG_20190704_164834_931.jpg
Field Maple BlackPearl (3).jpgField Maple GreenBlue (2).jpgField Maple GreenGold (2).jpgField Maple Red (2).jpgField Maple RedBlueTranslucent (2).jpg

The translucent ones were produced with my mate Dave G Designs. He used off cuts from precious blanks to create shavings and thin strips that he incorporated to create a stunning looking blank.
I can honestly say that I just loved every moment working with this maple. Its colouring, spalting and overal look was just amazing. Will be turning these shortly.
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
From your description of the process I too look forward to the turned results all that has taken place must result in success.

Peter.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top