• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

golum

Apprentice Member
Joined
May 7, 2020
Posts
36
Location
Cheshire
First Name
Andrew
turned fat for arthritic fingers, my first try with corian..

how many trips to the sharpening stone fgs????:thinks:


20200502_175111.jpg
 

flexi

Executive Member
Joined
Sep 12, 2014
Posts
6,159
Location
Maidstone
First Name
mark
Whilst it isn't to my taste, I admire the work and turning, finish is good too.:thumbs::thumbs:
I have to ask as to where you found a piece of Corian THAT big.....it's normally only 12mm square.....well done!
 

golum

Apprentice Member
Joined
May 7, 2020
Posts
36
Location
Cheshire
First Name
Andrew
Whilst it isn't to my taste, I admire the work and turning, finish is good too.:thumbs::thumbs:
I have to ask as to where you found a piece of Corian THAT big.....it's normally only 12mm square.....well done!

I got some corian off cuts that a kitchen fitter was dying to get rid of, one of em was a nice thick piece that came from a worktop he made....inch and a bit thick and about 18 x 24
 

Bill Mooney

Blind old git
Grand Master
Joined
Aug 16, 2014
Posts
10,997
Location
County Durham
First Name
Bill
Well done Andrew.:thumbs: Corian is easy to turn & I don’t find it hard on the tools. The piece you have could be mistral which is approx 1 inch thick.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top