• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

This is the Gauge

glenpen

Graduate Member
Joined
May 4, 2014
Posts
708
Location
Southport
First Name
Glen
This is the gauge referred to in my last Thread. Is there anything similar on the market.
Many Thanks
Glen
 

Attachments

  • 101_6276.jpg
    101_6276.jpg
    45.6 KB · Views: 59

nimrod

Graduate Member
Joined
May 10, 2013
Posts
418
Location
Lancaster
First Name
Robin
Glen if you look at Axminster Tools they do a Veritas Angle Gauge it has 7 angles from5 to 45 degrees.

Robin
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
It would be simple to make as this guage is handmade in your picture using a cheap Protractor to mark the angles,then cut out the shape.

Peter.
 

Ray7756

Full Member
Joined
Dec 4, 2017
Posts
198
Location
Kirkmichael Scotland
First Name
Ray
Or make angled blocks to go on your grinder rest to give you the required grind angles ??? So you fix the guides on your grinder rest then lay the tools on the rest and gently grind the correct angles
Cheers
Ray
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top