• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

polyester resin

Tiny James

Full Member
Joined
Oct 13, 2020
Posts
194
Location
Rugby
First Name
James
So last year I made a river table for my son and I have quite a lot of resin left over

would I be able to use the resin to make some blanks with out a pressure pot and can you thread polyester

I'm not going to make any blanks until the weather warms up anyway


James
 

Margo

Full Member
Joined
May 25, 2020
Posts
73
Location
England
First Name
Margo
What kind of resin is it?

I use glasscast for pen blanks without a pressure pot no problems.
 

fingwe

Registered
Joined
Nov 2, 2015
Posts
322
Location
Suffolk
First Name
Melanie
Depending on the cure time of the epoxy you should be ok, as epoxy usually takes around a day to set, allowing the bubbles to come out, but what depth is it supposed to be poured to?

The other is a polyester resin, which (from memory) I think you should also be ok with, but they only sure way to know is to do a small test.

However, I’m assuming you didn’t do the river table under pressure, so we’re there any bubbles in that? If not then you should be good!

Be careful with both though, use a very well ventilated area, neither are particularly pleasant chemicals to be using indoors where you spend a lot of time.
 

Phil Dart

Moderator
Executive Member
Joined
Nov 28, 2014
Posts
5,455
Location
Colebrooke, Devon
First Name
Phil
Don't bother trying to use the polyester stuff for your custom pens James, in any area of the pen that needs to hold a thread - it's great for kit pen blanks but it's too brittle for threading.
 

wm460

Grand Master
Joined
Mar 16, 2013
Posts
23,095
Location
Tennant Creek, Northern Territory, Australia.
First Name
Mark
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top