• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Aluminum Knurl....Again

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
Nice pen. You could always do a diamond knurl or even a straight knurl but best done on a metal lathe and even better done with a scissor-type rather than a single point tool
 

angelo49

Registered
Joined
Jun 19, 2013
Posts
2,827
Location
Lancaster, PA Brooklyn, NY USA
First Name
Angelo
Nice pen. You could always do a diamond knurl or even a straight knurl but best done on a metal lathe and even better done with a scissor-type rather than a single point tool

Derek, I have both a wood and metal lathe.
I thought about a full knurl and maybe cut out 1/4'' wide rings.
I might give that a try.
111a.jpg
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top