• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

sharpy

Apprentice Member
Joined
Jan 16, 2014
Posts
33
Location
north derbyshire
First Name
matt
A couple of rings I've made recently.
Composite metal blanks on 2 piece stainless steel cores.
 

Attachments

  • IMG_20180926_214947_222.jpg
    IMG_20180926_214947_222.jpg
    54.7 KB · Views: 61

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
Terry my experience buying ring components in the USA was there is another set of standard sizes. What I did was get one of Wilmas best fitting rings measure it from a jeweller here,look up for a comparison chart on the internet. Worked out fine. Making rings and arm bracelets ad hoc can be a loss.

Peter.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top