• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

yorkshireman

Wood Rat
Executive Member
Joined
Jan 5, 2013
Posts
5,199
Location
wrexham
First Name
Keith
Very good Keith, how big are they and did you turn between centres? :funny::funny:

20.5mm all to within +- 10 thou. Cut on bandsaw then accurately dimensioned using drum sander and disc sander. Drilling accurate holes was the worst part.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top