• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Frederick

Registered
Joined
Apr 8, 2018
Posts
871
Location
Chatham
First Name
Frederick
Hi

This is the biggest item I have turned. It is hollowed out to 40mm of the bottom but not sanded. It has been scraped on the inside. I di dn't use a steady either so was bricking it a bit.

View attachment 43510

20210408_165736[1].jpg

Cheers
Frederick
 

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,676
Location
Kent
First Name
Derek
Nice job [MENTION=1856]Frederick[/MENTION] you have done a great job.

How thick did you go with the walls, also how big is it as a steady is not always needed. I do love the challenges that hollowing brings what with having to stop and check the thickness of the walls as I progress down the form.
 

flexi

Executive Member
Joined
Sep 12, 2014
Posts
6,145
Location
Maidstone
First Name
mark
Very nice job mate, I love a good firewood vase/bowl... That's the thing with wood(and someone's pics) you never know what your going to get:whistling::whistling:
Very classical shape on that too, really nice
 

Frederick

Registered
Joined
Apr 8, 2018
Posts
871
Location
Chatham
First Name
Frederick
Nice job [MENTION=1856]Frederick[/MENTION] you have done a great job.

How thick did you go with the walls, also how big is it as a steady is not always needed. I do love the challenges that hollowing brings what with having to stop and check the thickness of the walls as I progress down the form.

Hello Derek

I will PM you.

Cheers
Frederick
 

Pierre

Graduate Member
Joined
Sep 2, 2015
Posts
993
Location
Southern Central France
First Name
Pierre
With the hollowing, if you dont have a hollowing set up with huge handles and stops and lasers etc, May I suggest that you drill to just short of the depth you want with as thick a drill as you can, then using a scraper with a 15 degree burr on top of the bevel angled at about 30 - 45 degrees you gently remove the wood. If you are happy with bowl cutters etc to go deeper then that's fine but when you get to the trembly bit, the scraper works wonders. Just a suggestion. :winking:

There is no shame in using a forstner bit to remove the excess material in the middle to make life easier in the internal shaping.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top