There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.
To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.
I got a Clarke 40" lathe a while back and have used it quite a bit but want to get into pen turning, as it doesn't have a morse taper nor can a chuck be attached im not sure how to attach a mandrel if it is even possible at all, any help would be greatly appreciated. Thanks
Following on from the slimline “awareness pen” I finished a Tempest using the Sapphire Radiance blank.
I was hoping to do a “johnny5” and attach a pin on the clip.
Unfortunately Ive not been able to find a suitable pin.
Anyone offer any suggestions?
(The photo was vertical ☹️)
Dave
