• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

butter.thumbs

  1. wm460

    Tail Stock DRO.

    I have been threatening to do this for a long time, finally got around to do it. Biggest hold up was HSS, cobalt drills and end mill's wouldn't cut through the hardened stainless steel of the calipers, finally the carbide end mill arrived and it went through like hot knife though soft...
Top