• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

charger

  1. Penpal

    Ways to remove rust

    Stumbling in U Tube ideas . Use a plastic storage box. In each corner stand and anchor clear of the fluids rebar rods joined using steel wire,never copper cause of the way it goes funny.Piece of wood to sit across the top to hold the object in the centre. Mix laundry soda 3 or 4 tablespoons in...
    • Penpal
    • Thread
    • battery box charger parts place
    • Replies: 4
    • Forum: Off Topic
  2. wm460

    Li-Ion Battery to M18 Battery covertor?

    I have both Ni cad and Li Ion Milwaukee tools, the Ni cad battery are had it, I was wondering if any one had any experiences with these converters? USB Converter Adapter for Milwaukee V18 Li-Ion Battery to M18 Battery 18Volt NEW | eBay I have a Makita angle grinder ( Pic below)but no charger...
  3. wm460

    New Toy.

    Well new to me, I just picked up a Makita cordless angle grinder with a battery, cheap.:thumbs: Been wanting a cordless angle grinder for long time. Just have to buy a charger for it. Is this the correct charger? Cost heaps more than the A/G:rolling:
  4. ni9eofse7en

    Generic charger for Trend Air Pro

    Well it has been a while since I posted anything, but seen as how I am currently unemployed and on sick (I partially amputated my left thumb a week before my employer dismissed me for my union stance, Red Robbo rides again. Apparently I should have been shopping my colleagues for CCTV breaches...
Top