• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

existing

  1. Penpal

    Almost finished relocation of my 2014 VL150

    Almost finished relocation only need to hook up the dust extraction now in the next few days and back into it. I bought the bare lathe and fitted the variable speed control myself. The belt drive through the headstock to keep under the bench free. Mongrel job to instal because I used an existing...
    • Penpal
    • Thread
    • existing finished metal mongrel relocation
    • Replies: 7
    • Forum: Off Topic
  2. A

    Couldn't believe it

    So I finally took the plunge. After months of deliberating I have decide to build a new workshop 3 times the size of my existing one. Started the task of clearing out drawers, shelves etc this morning and moving everything into the garage. Its going to take at least 2-3 weeks. And then I've got...
    • andyl
    • Thread
    • existing lathe months order workshop
    • Replies: 9
    • Forum: Off Topic
  3. G

    Not winnng

    Just got a Jet JWA 1015vs lathe and now found out my supernova chuck want fit. I need an Inserter to change the thread but don't seem to be having much success , any ideas, if not what chuck is suitable for this lathe that would use jaws I already have for my existing chuck Glen:sob:
Top