howsitwork?
Graduate Member
That's very clever, I like that a lot
thank you both. It’s an interesting exercise in accurate turning.Very interesting subject, a good talking point. I like it as well. Well done.
Kelvin
Yes I’ve done the glass bottle one. Took it along to model engineering club “show and tell evening “ , left it on table and went for a coffee .Most entertaining as I listened to “how it must have been done “ discussion. The other two wood turners in the club also kept quiet and enjoyed it .I have seen this as well from David Springett's books. Not sure if he did this but there is also an arrow made from a single piece passing through a glass bottle with two rings around the shaft.
Well done on getting the sizes right to make this otherwise the poor mouse would not get in
PhilVery creative Ian. How is the mouse captured? Is it a matter of squeezing him through a hole that's slightly too small?