• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Mitre Gauge

Walter

Moderator
Fellow
Joined
Apr 22, 2013
Posts
2,697
Location
Amble on the sunny Northumberland coast.
First Name
Walter
I was never really happy with the flimsy plastic mitre gauge that came with my cheap Chinese Axminster belt and disk sander, but none of the after market ones I could find came with a bar that would fit the 5/8" x 1/4" slot (not even Axminster's own brand ones)

Solution - I bought one from Axminster's North Shields store and modified it by fitting my own 5/8" x 1/4" mild steel bar.

Half an hour's basic metalwork and here we have it:

32532290676_8048e38ebd_z.jpg


32450503511_0068a718d1_z.jpg
 

GeordieB

Registered
Joined
Dec 26, 2014
Posts
2,979
Location
halifax
First Name
george
:thumbs::thumbs:did something similar for my endtrimming jig and made oak ones for my different bandsaw jigs
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
Sensible and should follow a thorough setting up of the guide slot to the Disk to promote accuracy. I like the width of the mitre guage almost up to the disk.

Peter.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top