• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Tail Stock DRO.

wm460

wm460

Grand Master
Joined
Mar 16, 2013
Posts
23,095
Location
Tennant Creek, Northern Territory, Australia.
First Name
Mark
I have been threatening to do this for a long time, finally got around to do it.
Biggest hold up was HSS, cobalt drills and end mill's wouldn't cut through the hardened stainless steel of the calipers, finally the carbide end mill arrived and it went through like hot knife though soft butter.:thumbs:



I need another collet chuck the MT3 to MT2 adaptor is to long and front heavy,and bloody awkward.

 
B

Bigblackdog

Registered
Joined
Dec 28, 2014
Posts
839
Location
Leeds
First Name
Mark
I like that. may have a go at doing something similar for accurate drilling. what is the red part- just something to connect the duo to the quill?
 
wm460

wm460

Grand Master
Joined
Mar 16, 2013
Posts
23,095
Location
Tennant Creek, Northern Territory, Australia.
First Name
Mark
Bigblackdog said:
I like that. may have a go at doing something similar for accurate drilling. what is the red part- just something to connect the duo to the quill?
Click to expand...

They are steering linkages for RC cars, something like in link below.

I bought two separate linkages without the adjusting bit in the centre, cut the head of a bolt off and tightened them up with a dob of CA for lock-tight. My lathe is a 9 X 20 so every mm is precious.

2x RC1:10 Model Car Upgrade Alloy Grey 102017/02012 Linkages Steering For HSP | eBay
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top