• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Making an index plate

angelo49

Registered
Joined
Jun 19, 2013
Posts
2,827
Location
Lancaster, PA Brooklyn, NY USA
First Name
Angelo
Started this a few months ago and put it aside.
When done (??) I should be able to mount it on the
left end of the headstock spindle of my Clausing metal lathe
and the wood lathe. 7-1/4'' x 60 tooth saw blade. Even with
carbide tools on the metal lathe it was tough to cut out the disc.
INDEX PLATE.jpg
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
Two locating holes 60 indexing holes gives you a good range of indexing.Some holes are larger than others. Interesting when you finish.

Peter.
 

angelo49

Registered
Joined
Jun 19, 2013
Posts
2,827
Location
Lancaster, PA Brooklyn, NY USA
First Name
Angelo

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
Progress mate waiting for the finished job. When I was making mine I went to the most accurate source who stuffed it up and I used meshing gears.

Peter.
 

angelo49

Registered
Joined
Jun 19, 2013
Posts
2,827
Location
Lancaster, PA Brooklyn, NY USA
First Name
Angelo
Penpal;284205]Progress mate waiting for the finished job. When I was making mine I went to the most accurate source who stuffed it up and I used meshing gears.

I could have looked for a 60t gear but it's more fun this way:thinks:
OR, it might be ''a penny wise and a dollar foolish''
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
On U tube one time I viewed a guy making his indexing device another way apparently there are so many ways to do this. THere are many sources of drilled disks and pin connections around. I realised accuracy and infinite care are needed. Good luck mate. From my memory Clausing made some beaut metal lathes. What model Clausing is your lathe?

Peter.
 

angelo49

Registered
Joined
Jun 19, 2013
Posts
2,827
Location
Lancaster, PA Brooklyn, NY USA
First Name
Angelo
What model Clausing is your lathe?
Peter, It's a1947 Clausing Model 111 MK 3a I'm going to scrap the index disc
for now. I just bought a 60T 12DP Gear (4-7/8'' dia.) on ebay for $17.00 delivered
111a.jpg
60 tooth gear.jpg
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
My 1966 Hercus is related to your lathe in a round about way my drive is a P Pattern .

Peter.
 

Attachments

  • Hercus and Dremel 6-27-2008 11-46-043.JPG
    Hercus and Dremel 6-27-2008 11-46-043.JPG
    155.9 KB · Views: 16
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top