• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

My new work bench

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
I picked this desk up on freecycle thought it would be great to do some pyro work and piercing work on as well as painting if I make a false top so that it holds the bowl when tipped upwards. It can be angled at varying degrees up to about 60 to 75 degrees. It was wobbly when I got it and all it needed was all the bolts tightening all nice and sturdy now. It has even two sets of draws under neither for some of the odd bits and pieces and also a retractable lip at the bottom which stop paper and the like from slipping off.
 

Attachments

  • DSCF7808.jpg
    DSCF7808.jpg
    46.3 KB · Views: 83
  • DSCF7809.jpg
    DSCF7809.jpg
    39.3 KB · Views: 83
  • DSCF7810.jpg
    DSCF7810.jpg
    39.6 KB · Views: 83

Bill Mooney

Blind old git
Grand Master
Joined
Aug 16, 2014
Posts
10,997
Location
County Durham
First Name
Bill
Oooh! Pyro & piercing, that's got to be more painful than tattooing & piercing. Nice operating table though Derek.:funny:
 

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
It is an ideal table and has wheels so can sit on the patio doing my decorating and spraying of the turning when the sun shines
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
Looking forward to seeing the angle rest etc. Good luck with the sun mate sounds a bit hot alround over there lately. Minus 6 this morning here.

Peter.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top