• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Organising micromesh

Bigblackdog

Registered
Joined
Dec 28, 2014
Posts
839
Location
Leeds
First Name
Mark
How do members organise micromesh? I have used the sheets and the foam pads before, and need to buy some more of one type or another now. The pads are slightly easier because they are different colours, but it is all too easy to lose the card that comes with it. The sheets are all various shades of grey.

Does anybody have any suggestions of how to organise it so that it stays in the correct order? I was thinking perhaps some saw cuts across a piece of wood for the pads. I have no idea on the sheets- a keyring in the corner, maybe?
 

Morse

Graduate Member
Joined
Dec 20, 2016
Posts
679
Location
Cheshire. UK
First Name
Dave
I was to advised to put the micro mesh pads in the correct order, then using a permanent markers raw a "V" top to bottom. That gives a visual order for the pads.

Dave
 

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,301
Location
Somewhere in Staffordshire,
First Name
Eamonn.
I cut the sheets in to small sizes and then use a box with them marked up on the lid.

I have two pieces in each tray so o know which tray to replace it in.

3C776B94-9FAB-4285-A766-8D8EB221C1C2.jpg
 

Lons

Fellow
Joined
Dec 17, 2013
Posts
4,753
Location
Northumberland
First Name
Bob
I just mark the back with a felt tip stack one of each on edge in a small tub then put back in place after use and pick up the next grade.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top