• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Workzone lathe

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,301
Location
Somewhere in Staffordshire,
First Name
Eamonn.
Hi Ray and welcome on board.

It all depends what you want to do and if you are willing to put up with the pain of getting stuff modified to suit the headstock thread. It has an 18x2.5 pitch which is NONE standard and can not get chucks or faceplates off the shelf.

I think £40 sheets is OTT in my opinion as they were only £89 new.

In my opinion you would be better looking for a 2nd hand Axminster or record lathe,

They workzone will spin a bit of wood but limited to what you can do with it as far as “extras” is concerned
 

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
I am not saying they are bad but if you own a boat buy it as an anchor it will get more use that way. Seriously as Eamonn says finding bits to fit is a right royal pain in the a**e. Save up for something better and you will not regret it Clarke lathes use to be the same.
Lathes which have a 3/4" X 16, 1 X 8 and the more commonly M33 x 3.5mm which a lot of manufacturers seem to be heading towards.
Turning can become very expensive so picking the correct lathe will start you in the right direction
 

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,301
Location
Somewhere in Staffordshire,
First Name
Eamonn.
Lathes which have a 3/4" X 16, 1 X 8 and the more commonly M33 x 3.5mm which a lot of manufacturers seem to be heading towards.

The only thing I wouldn't add is go for MT2 (Morse Taper size 2) head and tail stock fitting.

Oh, and if you wanted to use it as an anchor make sure it's unplugged first..:funny:
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
I am all for the No 2 morse taper in the head and tail stock also a reasonable length on the bed, a minimum of at least 9 inches swing helps.Also spinning on true easily replaceable bearings better than fixed ones that require constant lubricatin.

Peter.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top