• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Sorby Micro Sandmaster (Head only)

cclover

Apprentice Member
Joined
Jul 8, 2018
Posts
3
Location
South Carolina USA
First Name
Chaz
I'm thinking about getting the Sorby Micro Sandmaster head-only kit.

I do mainly small projects - custom fly tying tools, drop spindles for spinng, etc.

Is this a worthwhile tool?

I want to turn my own handle, so I'm particularly interested in what the dimensions of the tenon are (width and diameter). If anybody owns or has access to one of these tools could I get measurements?

TIA

</chaz>

Rock Hill, SC
 

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,304
Location
Somewhere in Staffordshire,
First Name
Eamonn.
[MENTION=1903]cclover[/MENTION]

Will this do!

View attachment 36371

Has been used quite a bit but not much recently as not done much turning due to health issues..

But that will change soon I hope..

Hat said it is a useful tool but found that I needed to "feel" the sanding operation at times so kept popping back to by hand when it was accessible.
 

Attachments

  • IMG_0506.jpg
    IMG_0506.jpg
    39.5 KB · Views: 43

cclover

Apprentice Member
Joined
Jul 8, 2018
Posts
3
Location
South Carolina USA
First Name
Chaz
Silver!

Thanx for the prompt response.

What I was hoping for is the measurements for the part of the head unit that inserts into the handle. The "male" part?

BTW, is that a "micro" tool in the picture or the full size?
 

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,304
Location
Somewhere in Staffordshire,
First Name
Eamonn.
[MENTION=1903]cclover[/MENTION]

The end you want measured is bonded in place so there is no way I can get that measurement..

That said as per William said above, the sizes of them should be 5/16 (8mm)

But if you want to be certain then get in touch with your supplier.

The one in the pic is a full size one, I have a micro one in the workshop but wasn't attached at the time of taking the pic..
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top