• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Robert Sorby 1" x 8tpi insert

webby962

Full Member
Joined
Jun 29, 2016
Posts
114
Location
Nr Letchworth
First Name
Adie
Good afternoon all,

Very quick question (i'll caveat it with I am away from my lathe so I can't check this myself), but what spanner size is needed to remove or fit the Robert Sorby 1" x 8 tpi to the Patriot chuck or to remove the chuck from the spindle. Is it 38mm (1.5" in old money)?

Adie
 

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
Good afternoon all,

Very quick question (i'll caveat it with I am away from my lathe so I can't check this myself), but what spanner size is needed to remove or fit the Robert Sorby 1" x 8 tpi to the Patriot chuck or to remove the chuck from the spindle. Is it 38mm (1.5" in old money)?

Adie

I can check tomorrow if you don't get an answer tonight
 

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
The nut is 1 1/2" as I took the measurement from that as it just happened to be on the bench
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top