• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Birthday Present

Neil Lawton

Longlocks
Fellow
Joined
Dec 26, 2013
Posts
3,115
Location
York
First Name
Neil
So, it was my birthday on the 4th and this turned up on the 6th.

cutter_631x480.jpg

By the time I got in I was too tired to open it!
Got it open and set up by the 8th.

cutter1_604x480.jpg

Couldn't for the life of me get the bloody software to work properly until I found a forum on it and did my first successful engrave and cut yesterday. Just a gift voucher so no pics, but I'll post results when I do something more interesting.
 

Phil Dart

Moderator
Executive Member
Joined
Nov 28, 2014
Posts
5,455
Location
Colebrooke, Devon
First Name
Phil
Plenty to have to learn about there I would think. Love the castors on the base by the way - is that a Lawton enhancement?
 

Neil Lawton

Longlocks
Fellow
Joined
Dec 26, 2013
Posts
3,115
Location
York
First Name
Neil
Plenty to have to learn about there I would think. Love the castors on the base by the way - is that a Lawton enhancement?

Yes Phil, I took the base of the crate apart, cut it down a bit, and used some bits that were on top to strengthen underneath and added the castors. It has an offboard water and air pump so I wanted to be able to wheel it out to get to them when needed.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top