• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

What in the earth.

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
Could be used for holding a blank for Blind end pens ,if the lhs piece slides on the rhs shaft endless uses. If they fit it would make a press for glueing up segment designs.

Peter.
 

fortress

Registered
Joined
Apr 11, 2016
Posts
5,178
Location
Astley
First Name
John
You mean “ what on Earth” Joseph, you got them on e bay, were they part of something you bought? :thinks::thinks:
 

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,301
Location
Somewhere in Staffordshire,
First Name
Eamonn.
I believe it's an early slimline pen mandrel, little like a mandrel saver.

If I remember the small piece used to have a bearing fitted in/on the small Diameter end to allow the shaft to rotate easily.

If I remember rightly Craft Supplies UK used to sell them when they were based at Millers Dale.

Both the ends are tapered to an MT2 and the shaft should be around 70mm long.

That was based on adding your Bushes and turn one tube at a time.

I believe that the bearings used to fail very quickly and was a poor design as the bearing was a ball race type that wasn't designed to have sidwards pressure..

That's my fourpenoth

I gather you must have purchased a bulk lot of stuff of e bay from someone who used to do wood turning.?
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top