• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Burt25

Full Member
Joined
Apr 29, 2016
Posts
147
Location
N Ireland
First Name
Ian
Has anyone turned perspective rod? I would like to mock up a kitless in coloured translucent perspex (which I believe is basically acrylic) so I can clearly see how much wall thickness and space I have internally. Will this turn / thread well?
 

21William

Fellow
Joined
Jan 21, 2016
Posts
1,618
Location
Dorset
First Name
William
Yes it turns well with sharp tools provided you don't get the speed too high. Not tried threading it as far as I can remember but I don't see why it shouldn't take a decent thread.
 

Burt25

Full Member
Joined
Apr 29, 2016
Posts
147
Location
N Ireland
First Name
Ian
Thanks William, I'm going to give it a try as it's not overly expensive at about £9 for 20mm x 200mm rod
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
Caution it threads well, cut well but is a pain in the rear to maintain a clear finish, I used a material already made following the long reports of folks who have done this as per this pic enclosed the receiving thread was inserted into the shell, there is not enough thickness in the shell to thread.

Good luck..........Peter.
 

Attachments

  • DSCF8467.JPG
    DSCF8467.JPG
    43.7 KB · Views: 68

Lons

Fellow
Joined
Dec 17, 2013
Posts
4,753
Location
Northumberland
First Name
Bob
No real problems turning and machining acrylic but with care!
Cleaning the inside of a drilled holes is a pita and difficult to polish if that matters while outside turning and polishing is very easy. be careful when drilling for breakout, very careful with thin sections and don't overheat the acrylic or it will crack or craze.

Acrylic was / is used in many machines, vending and pub industries for example and I have a demo piece somewhere with multiple polished and threaded holes.

One other consideration, there are 2 main types of acrylic manufacture which gives the material different properties, those are cast or extruded. Cast is much clearer, more stable and by far the best for our purpose while extruded is softer, absorbes more moisture and has extrusion marks which can be difficult to remove. From memory, most rod is extruded while sheet is available in both so use say 20mm cast sheet where you can. Cast btw is also more expensive.

I was lucky enough to aquire a number of offcuts when I was in the industry - just sitting there waiting for the right projects :goesred: I do look at them occasionally! :ciggrin:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top