• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Clear Epoxies.

Skin-Job

Full Member
Joined
Oct 6, 2017
Posts
172
Location
London, England
First Name
Karl
Hello again.

Due to my background in special effects work, and overexposure to polyurethanes, I'm drastically and dangerously allergic to them now.
I can't be near them in liquid state, the fumes, cured castings or the dust.
Last time I was hospitalized.

So, I've been doing some research into Epoxies. I have some wet samples whcih I'm doing some tests with.

Does anyone here work with clear casting Epoxy resins for blanks? If so, which resins?
Also, how do they find them for turning?


Many thanks,

Karl
 

fingwe

Registered
Joined
Nov 2, 2015
Posts
322
Location
Suffolk
First Name
Melanie
I've used Allumilte Amazing Clear Cast (the other Alumilite products are polyurethanes, but Amazing Clear Cast is an epoxy - though due to your condition, do double check I'm right). I don't like it as much as the polyurethanes, but it does work OK. It takes a while to set, and does go soft if it gets too hot - so be careful when polishing, but other than that, it works fine. I've also tried the Pebeo stuff (can't remember it's name, Crystal Clear? or something like that). That was very similar, but you can't get in in large volume, so it works out expensive. Oh, I've also tried Mastercast ( https://www.elichem.co.uk/p-21-mastercast-1-2-1-artwork-resin.aspx ) , though not for pens. Again, it worked fine, and although I didn't use it for turning, I did use power sanders, etc on it. Again it goes soft when heated, so be careful.
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
Was sad to hear of the effect casting has had on your health, thanks for fair warning mate and good luck on your next choices.

Peter.
 

Skin-Job

Full Member
Joined
Oct 6, 2017
Posts
172
Location
London, England
First Name
Karl
WM460,

If that stuff has the 'Characteristic styrene smell' then it's a polyester resin, and not an epoxy.
Epoxy has no real odour.

K
 

needastick

Apprentice Member
Joined
Nov 11, 2017
Posts
9
Location
Black country, England
First Name
Anthony
Z-Poxy do a clear casting resin, they make one or two different grades. I've done some casting with it but never turned it. Seems a good product though a bit pricey.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top