• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Micro Mesh with soap ?

mallard

Full Member
Joined
Feb 20, 2018
Posts
63
Location
Bristol, UK
First Name
Ian
I was watching a few clips on You Tube and see some people use soap and water when wet sanding with micro mesh.
Does anyone else use soap ?
Is there a benefit in using it ?
What soap do you use ?
 

Pierre

Graduate Member
Joined
Sep 2, 2015
Posts
996
Location
Southern Central France
First Name
Pierre
I dont wet sand with micromesh, I sand down to about 600 grit then apply sanding sealer and then sand dry with micromesh, water would in fact cause me problems.
 

mallard

Full Member
Joined
Feb 20, 2018
Posts
63
Location
Bristol, UK
First Name
Ian
I cant edit the original post !!!!
I would have thought using soap and water with Micro Mesh would not work very well just block up the mesh .....i use water when wet sanding with sanding pads but again i see people use soap with these as well.
Any benefit to using soap ?
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
The basis of any soap could cause ingress in timber ,on the other hand plastics are pretty immune to this.

Any trend to polish and run with timber is doomed.

Peter.
 

Curly

Graduate Member
Joined
Nov 3, 2019
Posts
421
Location
RM of Aberdeen, Saskatchewan, Canada
First Name
Peter
Micromesh was developed to polish scratches out of aircraft canopies etc and the soap and water helps wet out the surface of the plastic and micro mesh to keep it clean and cool. It cuts through any minor oil that might be on the surface. It was how I was taught over 45 years ago as an aircraft mechanic and it was not a new product then. You don't use a ton of soap, just a drop or two in a litre and if you are happy with using it without the soap then do so. Same goes for dry. I wouldn't use it on wood if you are only doing a few coats of thin CA but if going for the thick deep looking finish between centres so the ends are coated it works. I don't use micro mesh at all anymore, finding sanding to 400, followed by 0000 steel wool and then buffing to work better. The downside to working with water around your lathe is rust if you aren't fanatical keeping everything dry and protected.

Pete
 

Rod S

Full Member
Joined
Jun 8, 2020
Posts
12
Location
Winnipeg
First Name
Rod
Good morning from Winnipeg,

I use a drop of liquid soap (AFTER I apply 6 -8 coats of CA glue) and work my way though to 12000 grit. As Peter points out, a little care is required not to 'wet the lathe bed' but other than that, the final product is quite impressive. I also follow the wet sanding with a treatment of acrylic fiction polish.

This is the process I learned when I first started and the practice has been reinforced on many you tube videos. I understand that CA provides a 'different' feel to the pen so perhaps the debate should be the efficacy of CA vs other.

Stay safe,

Rod
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top