• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Engraved slimline in Ash

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,301
Location
Somewhere in Staffordshire,
First Name
Eamonn.
I have been asked on many occasions to do engraving on to wooden boxes or on to pens.

The latter I have always resisted as the pen just becomes another "engraved pen" that can be brought from any big suppliers for a few pence.

I have been working with a friend that has a C02 engraver but has never really got around to using it fully in the last year and saw it as a failed "to buy"..

So I pounced while the iron was hot and now the proud owner of a C02 laser engraver. I have modified it and built my own rotary axis so can now engrave pens if the need arises.

The pen on here is a first go at engraving that I thought I would have a play, especially for@johnny5;:winking: Took less than a minute to engrave. (about 5 mins to set up)

The pen is a fancy slimline with dragon engraving on the bottom section, turned out quite good and impressed so far.

I don't plan to do any specifics or promote the engraving of the pens, however a few specials will do no harm.


dragon 1.jpgdragon 2.jpgdragon 3.jpg
 

Graham_C

Fellow
Joined
Feb 1, 2017
Posts
1,153
Location
Tywyn
First Name
Graham
Not "just another engraved pen" Eamonn! Now it's a hand-turned pen that has been personalised :thumbs::thumbs:
 

johnny5

Registered
Joined
Oct 8, 2013
Posts
1,621
Location
Swansea
I have been asked on many occasions to do engraving on to wooden boxes or on to pens.

The latter I have always resisted as the pen just becomes another "engraved pen" that can be brought from any big suppliers for a few pence.

I have been working with a friend that has a C02 engraver but has never really got around to using it fully in the last year and saw it as a failed "to buy"..

So I pounced while the iron was hot and now the proud owner of a C02 laser engraver. I have modified it and built my own rotary axis so can now engrave pens if the need arises.

The pen on here is a first go at engraving that I thought I would have a play, especially for@johnny5;:winking: Took less than a minute to engrave. (about 5 mins to set up)

The pen is a fancy slimline with dragon engraving on the bottom section, turned out quite good and impressed so far.

I don't plan to do any specifics or promote the engraving of the pens, however a few specials will do no harm.


View attachment 32918View attachment 32919View attachment 32920

Looks great Eamonn , love the dragon :drool:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top