• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Closed end Mistral

Walter

Moderator
Fellow
Joined
Apr 22, 2013
Posts
2,697
Location
Amble on the sunny Northumberland coast.
First Name
Walter
Also finished today, one I started at a demo at Wear Valley Woodturners but didn't get time to finish. A closed end Beaufort Mistral in burr elm. Finished with melamine lacquer.

No closed end mandrel or other fancy kit was used. Started off on a standard mandrel with one bush and the other end supported with a revolving centre in the tailstock. Then parted off and mounted to complete the turning and finishing in a good old fashioned jam chuck turned from scrap.

IMG_4075.jpg


IMG_4074.jpg
 

Gregory Hardy

Graduate Member
Joined
Jul 7, 2017
Posts
454
Location
Upper New York State
First Name
Greg
Good for you, Walter. I don't know why folks don't follow that process - turning and parting at the end after using a live center in the tailstock. "Simple is often best." Well done.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top