• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Zeta and Mistral in Bog Oak

GSteer

Registered
Joined
Apr 9, 2015
Posts
362
Location
Soaked Cumbria, UK
First Name
Greg
It's been a while since I've finished a pen, or posted, so here's two. Both for my Dads 70th this weekend, should make him feel a bit younger considering the wood is thousands of years older than him!

Finished with melamine lacquer and matted with wire wool.

Zeta in Gun Metal / Chrome with English Bog Oak

67-001_Brythonic_20190221_705A2191_Web1024_.jpg
67-002_Brythonic_20190221_705A2192_Web1024_.jpg
67-003_Brythonic_20190221_705A2193_Web1024_.jpg

Mistral in Rhodium / Black Titanium with English Bog Oak
72-004_Brythonic_20190221_705A2203_Web1024_.jpg
72-005_Brythonic_20190221_705A2211_Web1024_.jpg
 

flexi

Executive Member
Joined
Sep 12, 2014
Posts
6,159
Location
Maidstone
First Name
mark
Two very well matched pens, very nicely finished.....you can see a lot of thought has gone into those...:drool::drool:
 

Terry Q

Fellow
Joined
Oct 8, 2014
Posts
3,847
Location
Roanoke, Illinois USA
First Name
Terry
I have not had the opportunity to turn bog oak. Its it difficult to work with? I like the subtle effect of the grain showing through the dark colour. Lovely pens.
 

GSteer

Registered
Joined
Apr 9, 2015
Posts
362
Location
Soaked Cumbria, UK
First Name
Greg
Thanks everyone! It's hard to tell in the photos, and get a wide enough dynamic range with the entire pen/background, but there are some lovely dense black grain rippling through the Mistral piece.

Terry: I've a selection of bog oak pieces which range from very flakey (which I think will require stabilisation) to very dense ones, I've only turned the denser/darker ones myself so far. A quick sharpen of the skews during turning was needed and it's a bit tougher to sand but I don't mind that. I tend to use a skew rather than a scraper as a I get the feeling that bits might fly off if approached like that due to the grain. On each I've turned so far I've had a couple of very small crevices where I've rubbed in the swarf and added CA to fill in, this is probably just me being overly cautious and not really required.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top