• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
Continuing that lovely taper in the top to a matching size in the lower end would join the two differently another time,like this pen for the effort and design Alan.

Peter,
 

Mark James

Full Member
Joined
Jul 19, 2014
Posts
261
Location
A Troll in the Basement - Ohio USA
First Name
Mark
Excellent craftsmanship Alan. I agree with Peter that matching the lower blank taper would typically be visually proper, but then the maple spacers between the inlays would have a resulting bulge (thinner at the ends, thicker in the middle). For this type of segmenting, I actually would have made the lower barrel match the upper - a more straight profile.

Great job on matching the layers, and keeping the end caps even. Very, very nice :banana:.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top