• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

end triming jig

GeordieB

Registered
Joined
Dec 26, 2014
Posts
2,979
Location
halifax
First Name
george
cobbeled this together today not very pretty but it works thanks goes to Terry as I am copying his

DSCF1375.jpg
 

woodhacker

Fellow
Joined
Aug 22, 2015
Posts
1,999
Location
Scot in exile in North East England
First Name
Peter also been called many others
George would I be right in presuming the blank will slide up the shaft towards the sanding disc. If so will you be able to put a full size blank on it? Thinking along the lines of an all in one pen:thinks:
Simple and effective though. :thumbs::thumbs:
 

GeordieB

Registered
Joined
Dec 26, 2014
Posts
2,979
Location
halifax
First Name
george
George would I be right in presuming the blank will slide up the shaft towards the sanding disc. If so will you be able to put a full size blank on it? Thinking along the lines of an all in one pen:thinks:
Simple and effective though. :thumbs::thumbs:

Not sure in all honesty Peter the tranfer punch in the chuck is approx 75mm I think
 

Lons

Fellow
Joined
Dec 17, 2013
Posts
4,753
Location
Northumberland
First Name
Bob
Shush George for heavens sake. When I made mine Terry muttered something about royalty payment, you'll set him off again.:ciggrin:

Looks good and solid marra :thumbs:
 

Woody

Registered
Joined
Jul 12, 2013
Posts
12,812
Location
at home
First Name
no
Well done George I still have the stuff to make one but just never got around to it
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top