Gadget-UK
Graduate Member
Hopefully this will work and I have it in the right place?
The Pen Stand that I made - 1 out of wood and the other out of Corian I used a template (Attached below)
This has been scanned onto an A4 piece of paper so make sure you print directly onto an A4 piece of paper so its the same size.
I have NOT added size of up-stands, the reason for this is the different height of pens available, one I made was great for the likes of the Epsilon but didn't look very good with taller pens.
Once you have cut out the top and bottom sections just lay a pen up against them and gauge what height you want the stand to sit at for your pens.
Again same with the slots.
The size on the drawing is great for larger pens but no good for Slimlines (They lean over way to much) so play around with different drill sizes.
Last bit of advice.
BEFORE you cut out the smaller (Top) section drill the holes / slots, makes it so much easier than trying afterwards.
For Reference:
The Pen Stand that I made - 1 out of wood and the other out of Corian I used a template (Attached below)
This has been scanned onto an A4 piece of paper so make sure you print directly onto an A4 piece of paper so its the same size.
I have NOT added size of up-stands, the reason for this is the different height of pens available, one I made was great for the likes of the Epsilon but didn't look very good with taller pens.
Once you have cut out the top and bottom sections just lay a pen up against them and gauge what height you want the stand to sit at for your pens.
Again same with the slots.
The size on the drawing is great for larger pens but no good for Slimlines (They lean over way to much) so play around with different drill sizes.
Last bit of advice.
BEFORE you cut out the smaller (Top) section drill the holes / slots, makes it so much easier than trying afterwards.
For Reference: