• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

geordie0928

Graduate Member
Joined
Jan 1, 2020
Posts
466
Location
Whickham, Newcastle-upon-Tyne
First Name
John Joseph
Hi, I'm thinking of trying my hand at casting, I was wandering if a Pressure Tank Pot Paint Sprayer Spray Gun Sprayer Regulator Agitator that you can buy on ebay be OK for a pot, or not. Can anybody shed some light on this for me. The paint mixer has been blocked off, so I don't have to worry about that.

5 Gallon 20L High Paint Pressure Pot Tank Spray Gun Automatic Mixer Agitator 928879551921 | eBay

Is this one suitable or not. What size should I be looking at would I need a 20 a10 or a 5lt tank.

:thinks::thinks::praying::praying::thinks::thinks:

Thanks.
 

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,340
Location
Canberra AUSTRALIA
First Name
Peter
THe needs you have outlined are broad. Internal size is determined by what you intend to do,allow for room to house carriers.Fully seekn out the nature and type of moulding or not. Pressure vessels need to be well made,sealed and preferably housed up to the lid as an additional safety measure. Within the boundaries of existing members this subject has been covered quite fully over time. Other forums have this as a perrennial and I trust you enjoy the thrust of the chase and your solution to it.

Peter.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top