• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Workshop time

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
At last I managed a little shop time by cutting some boards for a toy box build it did feel good.
 

Attachments

  • 20210125_184850.jpg
    20210125_184850.jpg
    36.8 KB · Views: 67

flexi

Executive Member
Joined
Sep 12, 2014
Posts
6,159
Location
Maidstone
First Name
mark
You can't beat a nice bit of workshop time, it stops that little nagging noise I get:whistling::funny::funny:
 

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
These board were originaly long one I was given and are 6" x 2" I just needed to resaw them to narrower boards at least that will prevent wasted time and wood getting them down to the correct thickness. They are now sitting in the spare bedroom to allow they to cup and twist before bringing them to the correct dimentions other wise I could end up with a wonky box
 

Dalboy

Executive Member
Joined
Mar 20, 2014
Posts
7,679
Location
Kent
First Name
Derek
Be careful or you will end up like me, suffering from domestic deafness.:roflmao::roflmao::roflmao:

I have a blocked ear which I can't seem to clear it does have it's advantages that if I sit with that ear closes to the wife I can't hear her:funny::funny::funny:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top