• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Garno

Fellow
Joined
May 12, 2021
Posts
1,372
Location
Dronfield
First Name
Gary
When a chuck is not tightened up or even on the lathe what level of movement is acceptable?
I have the allen keys tightened on the individual jaws and the chuck is open about 12mm (gap between top of jaws) and I have movement on each jaw of about 2mm towards the centre and outside of chuck is this an acceptable amount or does it not matter?
 

Curly

Graduate Member
Joined
Nov 3, 2019
Posts
420
Location
RM of Aberdeen, Saskatchewan, Canada
First Name
Peter
Just looked at my Super Nova and it does the same to a lesser extent but it wasn't mounted on the spindle so I couldn't push/pull too hard. I think you are fine. It is the tolerance between the jaws and the scroll they engage.

Pete
 

21William

Fellow
Joined
Jan 21, 2016
Posts
1,618
Location
Dorset
First Name
William
They seem to vary but my wood turning chucks don’t seem to be as good in this respect as my metal turning chucks.
 

howsitwork?

Graduate Member
Joined
Sep 18, 2019
Posts
513
Location
north york (gods own county)
First Name
Ian
Garbo

the chuck jaws will move slightly due to their fit in the scroll. ( unless it’s an independent jaw chuck) inside the chuck body .

To test concentricity grip a round piece of silver steel in the jaws and use a dti to measure 5h3 variation in rounds you spin it BY HAND NOT UNDER POWER !!!


To measure internal concentricity get a round bit of tube put it on the jaws and expand the jaws into it. Then measure the internal contact surface again using a dti fixed to an arm or magnetic base.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top