• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Polishing mops

alpha1

Fellow
Joined
Mar 29, 2018
Posts
1,175
Location
middlesbrough
First Name
Dave
I recently acquired a set of polishing mops to use on the lathe used them for the first time over the weekend to finish off a Polyester blank. It came up a treat. The blank was a nightmare to turn and sand. I lost two blanks due to blow ups. I bought four I have one left Out of the other three I ended up with the bottom half of a Mistral fountain pen. This last blank needs to make the cap. Fingers crossed.
Any one using mops.
 

alan morrison

Fellow
Joined
Feb 26, 2019
Posts
2,378
Location
Co. Down N Ireland
First Name
Alan
I use the 4 inch ones on a bench grinder. It saves taking off and putting on more things on the lathe.
The tripoli and white diamond are on the grinder and then the polishing mop I put on the lathe.

I think that they do a great job.

Alan
 

Curly

Graduate Member
Joined
Nov 3, 2019
Posts
421
Location
RM of Aberdeen, Saskatchewan, Canada
First Name
Peter
We have a Beall buffing set for the lathe. Three 8" wheels on the shaft. Use it for polishing CA finished wood pens and on acrylics of all kinds. Usually sand to 400 and then 0000 steel wool (lathe spinning and lathe off lenghtwise) and then buff from there.

Pete
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top