• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Router Table Fence.

wm460

Grand Master
Joined
Mar 16, 2013
Posts
23,095
Location
Tennant Creek, Northern Territory, Australia.
First Name
Mark
I am slowly getting my router table done, thought I must confess it is mostly used as some to put things an and buried.:goesred:

I am now up to the stage of making the fence, I was thinking about buying all the partsd whn I remembered this POS that has been sitting around and getting in the was for a long time.

I am looking for ideas of how to use parts frm it to make my fence.

Bugger some reason my photos will not up load.:sob:
 

wm460

Grand Master
Joined
Mar 16, 2013
Posts
23,095
Location
Tennant Creek, Northern Territory, Australia.
First Name
Mark
8558562978da12e55134b7eb105507de.jpg



Sent from my iPhone using Tapatalk
 

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,301
Location
Somewhere in Staffordshire,
First Name
Eamonn.
[MENTION=74]wm460[/MENTION]
Surely you only need to find a way of fixing the fence down and holding it in place!.

The ends loo like they adjust anyway, so secure tha back part and you should have it working. On mine both fences work independently so that you can set the following fence the same as the cut so you get a nice straight cut.
 

silver

General dogsbody
Executive Member
Joined
Jun 29, 2013
Posts
6,301
Location
Somewhere in Staffordshire,
First Name
Eamonn.
@Eamonn could you please post a photo of yours.

It’s at Siver by the way….. :rolling:

Mine is an elcheapo Aldi special, noting as sophisticated as yours is any way shape of the imagination.

Will see what I can get when I’m back home laters for you.

It just has two angle plastic pieces that are adjusted on a sliding slot and thumb turn to lock them in place.

I use it quite a lot on most of the same stuff for my hinges and opening lip recess of my boxes. Doesn’t get used for much else TBH. I have 6 routers now :goesred: each has a separate bit for specifics and saves loads of time setting them up for the different jobs I do regularly. Don’t know if it’s lazy or just switched on :funny:


EDIT..
Just had a recount….7 :rolling:
 
Last edited:
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top