• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

12mm

  1. TVS

    Another design watch stand

    Made thee two using 12mm corian very simple to make
  2. Morse

    Worst pen todate

    Well this started with my post asking about what wood shouldn't we use for pens. One moderator, Phil, said Balsa wood. So up for a challenge I bought a piece of 12mm X 12mm and cut it to fit a slim line kit that I had. Drilling no problem. First CA glued tube, in, second CA glued tube stuck...
    • Morse
    • Thread
    • 12mm glued sand tube wood
    • Replies: 25
    • Forum: Turning Pens
  3. Firefrode

    Turning cellulose paint

    Hi I have just been given some pieces of cellulose paint cracked from an old car and it has many layers. I have cut two pieces into 12mm square blanks and will hopefully turn a twist pen Any advice on turning layered paint?? Regards
    • Firefrode
    • Thread
    • 12mm 18194 cellulose mdn paint pieces turning
    • Replies: 12
    • Forum: Turning Pens
  4. flexi

    Which way!!

    OK quick question....this is for a jnr gent...as can be seen from the picture it obviously has an orientation it looks to be 13mm on the right which would be the middle band and 12mm on the left which is the bottom....but i think that puts the blank upside down...is this just me or should this...
    • flexi
    • Thread
    • 12mm band blank bottom left
    • Replies: 11
    • Forum: Turning Pens
Top