• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

dye

  1. D

    Gutted. Thanks Royal Mail :( dye burr Ash?

    I’ve been planning a pen set for my wife’s 30th next week for ages. I ordered the burr walnut after getting a suggestion on here for where to find some... It hadn’t arrived after far longer than expected so contacted the sender. It was returned to them yesterday in pieces, as he says, “looks...
  2. C

    Test

    Hope this works!! First time newbie. Its scrap wood and I had a go with wood dye. CA finish.
  3. Graham_C

    Red driftwood Sirocco

    Not sure what the wood is but it has a quite open grain with some spalting. Red dye added to the stabilising solution, Melamine finish.
  4. webby962

    Slight dyed Poplar Burl - Omega

    I had a go at doing a part dye stabilisation. I placed the blanks vertically in some dye and stabilising resin, and let capillary action draw it up to a bout a third. I then stabilised in cactus juice. The red didn't go a deep as I thought, but it is a start at adding a little interest into the...
Top