router

I am slowly getting my router table done, thought I must confess it is mostly used as some to put things an and buried.:goesred: I am now up to the stage of making the fence, I was thinking about buying all the partsd whn I remembered this POS that has been sitting around and getting in the was...

I have a cast iron router table-saw extension wing, that I dont use, as it a PITA to use, always in the way of the T/S. Sorry about the side way pic. I was thinking about making one out of MDF approx 685mm x 600mm The cast iron one is only 685mm X 255mm My router is a Triton, I have the...

On the Lathe. Anyone done this. Did you buy or make a jig for the router etc, what router do you use? I’ve seen this “fluting jig” but it’s a bit expensive if I don’t end up using it much. Paul Howard Woodturner: Jigs and Things I’d also need some kind of division plates to fit my lathe as well.

A Solid oak Celtic Design Wall plaque. 600 mm x 300 mm x 40 mm Engraved using my CNC Router

Thought I would take a break from the waggon and make a router jig to use on the lathe as I have a few ideas that I want to try. Managed to cut a few parts ready for it as well as a bed for it to run on. Still some cut outs to make before assembly comences

Just dug this out and gave it a clean up I think it is all there as most that I have seen are missing the router bits and the holder. Not sure what the large spring is for, the only thing that is missing are the instructions. And what is it worth

Well I have been planning on getting a new 2nd router for several months as having one plunge router doing the boxes has been a pain and really slows the job down. So after much deliberation and seeing one in action I decided to go for the Makita 18v battery powered one as I already have a jig...

1. Off square parts will assemble for maximum ill effect. 2. Your workshop is never big enough. 3. The workshop of your dreams won’t be big enough. 4. Mobile bases aren’t mobile in seven inches of sawdust. 5. Plastic wood isn’t. 6. A Safety guard hasn’t been invented that can prevent stupid. 7...

Important news - I have got to the bottom of the problem. If cannot get on the forum as a result of being timed out, it isn't because the forum has gone down or that it has a problem. The problem is 99.9% certain to be to do with your IP address. Everyone online has an IP address, which is a...

Every now and again I'm getting timeout errors when trying to access the forum - I've only just been able to access the site today after several days of having no access. It also happened a week, or so, ago. It appears to either be an issue with my router, or my ISP (talktalk), as I can't...

That is the question.... I have looked in to both and not looking at the specific software issues as I see those are little steps to get over and not a significant issue. What I ask is router or laser..? Simple question. What would you go for and why? Don't be shy, all you newbies and...