Can you indicate which Chuck and Top Jaws were incompatible - it may help others.The spigot height and width is also critical DAMHIKT !
axminster spigot height is about1 mm or so , some axminster ācompatible ā jaw slides had a 3mm high spigot so you canāt tighten them down properly ( even though screw spacing means they āfitā ).Can you indicate which Chuck and Top Jaws were incompatible - it may help others.
Axminster will sell you the jaws so ask if they fit first and tryout in the show room . Theyāre a good firm to deal with generallyJust to confuse things even more, just had the Vevor chuck delivered and it has male spigots on the carrier like on the Axminster chucks, not female as mentioned above.
Think I will sneak the chuck into Axminsters on my next visit and see if their jaws will fit.
Thatās a blow isnāt it.Hi all
Just to put this one to bed, I tried a set of Axminster jaws on my Revor and they didn't fit, the male alignment stub on the carrier jaw is wider on the Revor so although the screw holes lined up the stub was to big to fit the slot cut in the jaws.
My quest continues.
Paul